Expert Plumbing Services in Mission Viejo, California

In the cold weather, water can freeze in your pipes and cause pipes to break. A broken pipe can cause flooding and significant water damage in your home if it’s not mended immediately.

If you have a burst pipe, the beginning step is to disable your home’s water store. You’ll complete this at the main water shutoff valve, which is usually found in your utility area or basement. Rotating the valve clockwise will stop the water.

Then reach out to us at 949-762-8644 right away. Regardless if it’s behind a barrier, in your lawn or under your home’s foundation, we’ll be able to locate the burst pipe and mend it quickly.

If you aren’t using more water than normal and your bill doubles, there’s a good likelihood you have a water leak. Sometimes your dues will go up a bit. It’s harder to catch but will normally become more noticeable as the leak expands.

It could be hard to discover a water leak without professional assistance. However you can check your water meter to find out if the leak is inside or outside your home.

A little bit of mildew is usual in damp rooms like bathrooms. Although it’s not normal to find big amounts accumulating on a non-shower wall, the ceiling or on baseboards, particularly if these areas feel squishy to the touch.

A leaking pipe can make walls, ceilings and floors to feel soft or sag. It may also leave water blemishes on surfaces.

These issues can occur in spaces with poor venting or high humidity. But it’s especially problematic if you are witnessing other signs of a leaky pipe, like odd fungus-like smells.

Stagnant water can make an area smell stale. If the area also has moist walls or floors, you may have a water leak.

Your fittings can back up sewer water and cause disrepair when the water force descends in your house. This can be caused by a broken backflow preventer, sewer line deterioration or other municipal issues. Call us at 949-762-8644 at the initial sign of backflow and we’ll get it fixed quickly.

A few things can be the issue when your water pressure is low. There may be a obstruction in your plumbing fixture. It can also be caused by a broken water heater or a leaky pipe.

If you own a water heater with a tank, it has a limited capacity for hot water. If you’re getting cold water when you don’t use a lot of warm water, something could be wrong. Your boiler could be dripping, in need or repair or need to be replaced.

A block is probably to be at fault when your sink or shower empties too slowly. We use a special instrument like a drain snake to break it up and get your fixture draining correctly again.

If your toilet’s tank seal is broken, it will signal the tank to continue refilling. A toilet that continues refilling can suddenly drive up your water bills.

Your water should be see-through.

Don’t fret if it comes out dirty once in a while, as this generally just means there’s air in the water supply. If you see particles settling at the base of your glass, you should have your water tank inspected.

Water that’s any other color can be dangerous to your body. Listed are a few situations that can cause your water to be discolored:

• Brown, red or yellow—This is typically caused by a water main break in your area. It can also mean your pipes are deteriorated.
• Green or blue—This is very serious, as it means your pipes are most likely corroded. Your water can taste brassy or bitter on account of a high concentration of copper or lead. Long-term intake has been linked to serious health issues in adults and children, like intestinal illnesses, cancer and seizures.

If you’re observing discolored water or particles in your water, connect with us at 949-762-8644 and we’ll diagnose the problem.

If your toilet’s tank seal fails, it will signal the tank to keep refilling. A toilet that keeps refilling can rapidly drive up your water bills.